![Room setup](../img/forces_room1.jpg)
Room setup |
![Storage](../img/forces_storage.jpg)
After assembly, place all masses
on board for storage |
![clamp](../img/clamp_pos1.jpg)
Knife-edge clamp attachement |
![Clamp](../img/clamp_pos2.jpg)
Angle clamp to grip board and table |
![Correct pulley](../img/pulley_correct1.jpg)
Only use pulleys that have "cup" at end of
screw, as shown on the right. Don't use
pulleys without the "cup" (left) |
![Pulley attached](../img/pulley_attached.jpg)
Pulley attached to board |
![Pulley mark](../img/pulley_mark.jpg)
Notch on pulley clamp used to align string |
![Pulley alignment](../img/pulley_align2.jpg)
String will pass directly over clamp mark
(viewed from side) |
![Pulley alignment](../img/pulley_align1.jpg)
Align pulley so string is directly over mark,
as seen from above |
![Completed setup](../img/forces_board.jpg)
Complete setup |
![Top view](../img/forces_board2.jpg)
Setup, viewed from above |
![Bracket](../img/bracket_forces.jpg)
Forces on bracket |