St. Lawrence University homepage SLU Physics homepage

 

Electrocardiography - EKG
Instructor Notes

 

  • Computers are needed for lab this week
    • The laptops must be connected to their power bricks. There is too much signal noise if they are used without AC power connection. Power bricks are found in the non-Major's stockroom, shelf CC6
  • The wire from the EKG sensor labeled Lead I is connected to CH1 on the LabPro interface; Lead II is plugged into CH2
  • The quality of the EKG is very much dependent upon the 'patient' used. Some will produce a very strong signal, others are basically walking corpses. If someone has a weak signal (typically in Lead I, containing no discernable peaks – Figure 1), they can use the sample Logger Pro file "Sample EKG Data.cmbl" found on T:\Phys104 (used for step #9 and later – Figure 2). Also found on the T: drive is "Sample EKG Data - Lead I Reversal.cmbl" for student use
    • Here are my hand written solutions using the sample data. An average value of <r>=0.75 m was used
    • The good sample data was collected by Clifford Reilly '16 and Fletch Starnes '16 on 10 March, 2015
Bad Data
Figure 1 – Bad Data: Peaks not visible in Lead I

Figure 2 – Good sample data on T: Drive

 

  • Students need to be reminded about how to add vectors graphically. Make sure they're drawing them tip-to-tail
  • Throw away used electrodes when finished. The sheets of unused electrodes should be placed back in the foil envelope and used for later groups.
    • All open packages of electrodes should be thrown away at the end of the week; new ones will be used the following year

 

  • (Note: The Mathematica section has been removed as of Spring 2020) The Mathematica program, created by Brian Watson, can be a bit flaky. It will sometimes pause while running. Hit the play button to resume.
    • During Spring 2019 semester, Mathematica would crash when trying to print. The solution is to use the Windows 10 "Snipping Tool" to capture a screenshot of the graph, and print the screenshot
    • It's very important that students follow the directions of importing the data into Mathematica. They should not label the data columns, as this will confuse Mathematica

Return to Setup


© St. Lawrence University Department of Physics
Revised: 24 Mar 2022 Canton, NY 13617