Basic Idea:

• Examine Kirchhoff's Loop and Node rules.

	What:	How Many:	Where:
	40 volt DC regulated power supply	1	Majors storeroom, shelf C2
	Digital Multimeter	2	Majors storeroom, locked in steel cabinet
	Three resistors mounted on board (see sketch below and detailed photos)	1	Majors storeroom, shelf F4
	Single pole knife switch	1	non-Majors storeroom, shelf M3
	Banana-to-Pin adapters (should already be installed on the knife switch!)	2	Majors storeroom, shelf B2
	Small DC bulb (7.5 v, 0.22 A)	2	non-Majors storeroom, shelf M3
	Small DC bulb holder	2	non-Majors storeroom, shelf M2
	Alligator clips (for bulb holders – already installed)	4	Majors storeroom, shelf B2
	Wires (Split colors of wires evenly)	6 – 24" 2 – 12"	104 lab, and scattered about

Computers Needed?

• No.

• Lab setup (see this page for detailed photos):
  • Place circuit boards following letter pattern below
  • Note: Remove the A and V sticky notes from the multimeters!

• Three resistors mounted on board: