![](img/photoelectric-setup2017.jpg)
Two photodetectors per light source;
Note angled position on lab bench |
![](img/photo_slit.jpg)
Attach aperture to the light source. . . |
![](img/photo_slit2.jpg)
. . . using the middle groove. Tighten thumbscrews |
![](img/photo_grating_new.jpg)
The blazed diffraction grating mounts on end of aperture
assembly.
Note orientation of label and thumb screw on bottom; label must be
on the same side as the wire connections on the photohead |
![Photoelectric](img/photoelectric-grating-orientation.jpg)
Note that label on grating (red oval) is on same
side of photohead as wire connections (yellow oval).
The grating thumb screw should be on the bottom |
![](img/photo_bar.jpg)
Attach coupling bar assembly, again using
middle groove. Tighten thumbscrew |
![Photoelectric](img/photoelectric-light_block.jpg)
If only one side of the Hg source is used, insert a Light Block (yellow oval)
on the other side. Slide light block into the inner-most channel |
![](img/photo_support.jpg)
Place photoelectric head on support base,
connect to coupling bar |
![](img/photo_meter.jpg)
Connect multimeter; set it to 2 VDC |
![](img/photoelectric-head_connections.jpg)
Photoelectric head connected to DC power panel |
![](img/photoelectric-head_wires.jpg)
The top two wires (red & black) connect to the DC power
panel; the red & black wires on the bottom connect to the voltmeter. The purple wire connects to the panel ground |
![Power panel connection](img/photoelectric-power_panel.jpg)
Wire connections on power panel:
Red & black to top connections on photohead; purple to ground
|
![](img/photo_filter.jpg)
Place yellow and green filters on bench |
Dual Power Supply Connections |
![](img/photoelectric_dualie-power-supply.jpg)
Connect DC power supply (1-dual, as shown, or 2-singles)
to bench, and set
to ±9 volts |
![](img/photoelectric-dual-supply-alternate.JPG)
Spring 2023: I used a different dual-supply, one that has a separate ground connector for each side. I connected the two ground connectors with an additional 12" black wire and all seems to work properly |