St. Lawrence University homepage SLU Physics homepage

 

Re-Aligning a Compass Using a Magnetizer

  The small compasses that we use in lab are placed near strong magnetic fields during the Lenz's Law and Magnetism experiments. Frequently this causes the polarity of the compass to flip, resulting in student confusion when trying to determine the north pole of an 'unknown' magnet. The compass can be easily realigned using the following procedure:

  1. Determine if the orientation of a compass is reversed: use a known magnet for identification, recalling that B points away from the north pole of a magnet.
Backwards compass
Backwards compass; bump on magnet is north, so
the needle should point away from the pole
  1. Assemble the ETP Magnetizer (non-Major's stockroom, shelf JJ4). Place two old steel magnets and an iron keeper in the magnetizer; the polarity of the steel magnets doesn't matter.
Magnetizer
Magnetizer with two steel magnets & keeper bar
  1. Turn the magnetizer on, and hold a compass on the outside of one of the steel magnets as shown. Note that you can hold two compasses together on one side, and have a colleague hold two more on the opposite side of the other magnet.
Compass ready for repair
Backwards compass held in place for repair;
Note that compass needle points down.
Scaly skin optional
  1. Press the black button for a couple of seconds; the compass will spin around and its polarity will be changed!
Compass fixed!
Compass after repair; note that the compass needle
now points upward!
  1. Check the polarity of the repaired compass with the known magnet.

Note that you can reverse the polarity of any compass, whether its orientation is correct or reversed!

Checking repaired compass
Repaired compass correctly points away from
the north pole

 

 


© St. Lawrence University Department of Physics
Revised: 09 Nov 18 Canton, NY 13617