St. Lawrence University homepage SLU Physics homepage

 

Physics 103 Set Up Instructions:
Pressure And Buoyant Force
Lab Directions
BlackBoard Notes

Basic Idea:

Number of setups: Equipment Needed (each setup):

  What: How Many: Where:
Stuff left in place from last week's lab:
Large bench clamp 1 non-Majors storeroom, shelf C4
Short metal rod (40 cm long) 1 non-Majors storeroom, shelf A3
New Stuff:
Small plastic container 2 non-Majors storeroom, shelf HH3
Plastic jars,
large and small diameter
1 each non-Majors storeroom, shelf HH2
Vernier calipers 1 non-Majors storeroom, shelf BB3
Aluminum block with string 1 non-Majors storeroom, shelf HH3
Force gauge 1 non-Majors storeroom, shelf F2
Pendulum clamp 1 non-Majors storeroom, shelf C3
Roll of masking tape 1 In the lab
Place the following items on the sink (shared):
100 ml beaker 2 or 3 non-Majors storeroom, shelf HH3
Sand Two small
plastic containers
non-Majors storeroom, shelf HH3
Cardboard box lid (from paper box) 1 non-Majors storeroom, shelf HH3
Electronic Balance 1 or 2 Jeff will get this
The following items are for the pre-lab demo:
Small plastic container 1 non-Majors storeroom, shelf HH3
Aluminum block with string 1 non-Majors storeroom, shelf HH3
Large force gauge 1 Lecture-demo room (Jeff will get this)

Notes:

  • Return To Setup Instructions


    © St. Lawrence University Department of Physics
    Revised: 14 Dec 2023 Canton, NY 13617