Room setup |
Stuff needed: Knife switch, galvanometers (old & new),
red coils ("large" and "small"), 100kΩ resistor, compass, bar magnet,
wires (two 12", two
24", one 36"/48") |
Resistor holder
with 100 kΩ resistor |
Knife switch with two
banana-to-pin adapters |
Old (left) and new galvanometers
Old one is used when a bolt is placed inside electromagnet |
Coils (large and small) |
Exit Test stuff (set up on right front bench):
galvanometer, yellow coil, "unknown" magnets |
“Unknown” magnets have ends taped up and labeled |
Box O'Bolts place on instructors bench |