![](../img/DCMotor04.jpg)
The setup: DC battery, copper wire, rubber bands,
sand paper, safety pins, wood v-block, compass |
![](../img/DCMotor03.jpg)
Wire cutters and Sharpie markers on instuctor's table
|
![](../img/DCMotor01.jpg)
Extra parts on small bench by sink: magnets (leave
in box!),
small pieces of insulated wire, copper wire, rubber bands |
![](../img/DCMotor02.jpg)
More extra parts: sand paper, nails, safety pins, compasses, wood blocks
|
![](../img/DCMotor05.jpg)
The assembled motor in action |
![](../img/DCMotor07.jpg)
Extra coils are left as samples |
![](../img/DCMotor-wire-spool.jpg)
Copper wire spool gets attached to small front bench near blackboard.
Note that the clamp remains attached to the bench; pack the rod and end clamp with the wire spool. |