Physics 104 Setup
Details:
The Equipotential Surfaces of a Dipole
(click each photo for a larger image)
Return
to main setup page
 Room setup |
 Conducting board attached to red and black connectors on bench |
 Metal push pin holds one end of each wire with eyelets to the charge, and the other end to the upper corner of the board. An aligator clip connects the long wires from the power panel to the pins in the upper corners of the board. |
 The wires wires with eyelets are held by four metal push pins, and four more pins hold the edges of the paper. Note that the coordinate axis is written in pencil on the conducting paper. |
 Dual power supply (preferred) on instructor's bench. See setup instructions for wiring directions |
 If a dual power supply is not available, place two single power supplies on instructor's bench. See setup instructions for wiring directions |
|
|
||
| © | St. Lawrence University | Department of Physics |
| Revised: 21 Jan 25 | Canton, NY 13617 |