Basic Idea:

• Measure the potential field of two "charges"

• 7

	What:	How Many:	Where:
	Pasco Field Mapper Kit	1	non-Majors storeroom, shelf L5
	Thin wires with aluminum eyelets (red and black)	1 each	Inside Field Mapper Kit storage box
	Conducting paper with drawn charges	1	Inside Field Mapper Kit storage box
	Metal push-pins	6	Inside Field Mapper Kit storage box
	9-volt DC battery	1	non-Majors storeroom, shelf L3
	Digital multimeter	1	Majors storeroom, locked in steel cabinet
	Meter probe wire (red)	1	Majors storeroom, hanging in the center aisle
	More wires: 24" red 24" black 48" black	1 each	Bewkes 231 (Phys 152 Lab)
	Alligator clips (red and black)	1 each	Majors storeroom, shelf B2
Place two extra multimeters on the instructor's bench (for spares) and a roll of masking tape
	Digital Multimeter	2	Majors storeroom, locked in steel cabinet
	Masking tape (to secure wires)	1	In the lab
The following components are installed on front bench; Ask Jeff if we're using Two single- or One Dual-power supply!
	Either: Dual power supply (Tenma 72-7245 preferred)	1	Majors storeroom, shelf C2
	Or: 40v regulated power supply	2	Majors storeroom, shelf C2
	Digital Multimeter	1	Majors storeroom, locked in steel cabinet
	Wires	Black 12" – 2 Red 12" – 1 Black 24" – 2 Red 24" – 2	Bewkes 231 (Phys 152 Lab)

Notes:

• Lab setup (see the photo details page as well as the wiring diagrams below):

  

• Main power supply connection:
  • Note: The big power supply in the stockroom is used to distribute voltage to the lab benches from the lab power supplies. Jeff will take care of this following his instructions for configuration with an external power supply
  • A power supply on the instructor's bench is used to provide ±15 V to all the connected boards. Depending on availability, one dual-power supply (each side set to independent) will generally be used (Figure 1). If a dual-power supply is not available, two single-power supplies are connected in series (Figure 2)
    • Note that Figures 1 and 2 show a green wire connecting the power supply's GND connector to the green ground on the power panel. A 12" black wire is used for this connection
  • Set the power supply voltage as follows (note that this procedure is illustrated in the Instructor Notes for the Photoelectric Effect):
    • Connect the black wire of the voltmeter to the green panel connector.
    • Connect the red voltmeter wire to the red panel connector, and adjust the right side power supply to +15V
    • Move the red voltmeter wire to the black panel connector and adjust the left side power supply to -15V

Figure 1: Connection of Dual Power Supply	Figure 2: Connection of Two Single-Power Supplies

• Board connection; follow the correct polarity for each board (-15V on the left screw head, +15V on the right):