Basic Idea:

• Velocity and acceleration: What's the difference?

• 7 

Equipment Needed (each setup):

	What:	How Many:	Where:
	Vernier Motion Detector & cable	1	non-Majors storeroom, shelf E5
	Vernier LabPro interface	1	non-Majors storeroom, shelf E5
	Vernier LabPro power & USB cords	1	non-Majors storeroom, shelf E5
	1-m Meter stick	1	non-Majors storeroom, shelf AA1
	30-m tape measure	1	non-Majors storeroom, shelf AA3
	Wood Drafting board (Put near each setup)	1	non-Majors storeroom, shelf J2
4 Computer Carts Are Needed (3 in Hallway + 1 Near Sink!)
	Computer cart for laptop	1	non-Majors storeroom, back row
Other stuff
	Power strips	3	Jeff's office
	Extension cords (6' & 25')	1 each	Jeff's office
	Wood platform - total needed: 6 - one for each cart + Bewkes 202 setups! About 9 cm tall	1	non-Majors Storeroom, shelf J3

Notes:

• Lab Setup (three setups in the lab; three setups in the hallway; (if needed) 2 setups in Bewkes 202; see the photo details page):
  • This experiment is set up in Bewkes 231; signs for 103/151 lab swap (on Jeff's OneDrive) need be posted in the hallway
  • Flip up the top part of the motion detector and slide the switch to the right to set to 'human' mode! (photo at right)
  • Desktop computers are used for setups #1 and #2; use laptops for #3, #4, #5, #6, #7 and #8.
  • Setup #3 (near the sink) needs a cart to move the motion detector away from the board
  • Computers #4, #5 and #6 are moved out into the hall before each lab, then stored away at the end of the day
  • Position the motion detector to the right side of the cart for computers #4 and #6; these carts will sit on the left side of the hall. The motion detector on cart #5 should be positioned on the left side; it will sit on the right side of the hall. See photo details for position in hallway.
  • A small wood platform is needed under each motion detector on a cart, as well as in Bewkes 202. In 202, the platform will elevate the motion detector above the bench, causing less interference. See photo details.

 

---

 

 

Vernier Hardware (photos courtesy Vernier Software & Technology)
Vernier LabPro Interface
Vernier Motion Detector